The shell, from the inside out
| Layer | Typical | Why it matters |
|---|---|---|
| Acrylic skin | Thin, vacuum-formed | What you touch. Too thin to have value on its own. |
| Fibreglass backing | Resin-bonded layers | Structural. Cuts dusty, and dulls blades. |
| Polyurethane foam | Sprayed on | Insulation, and the reason nothing separates cleanly. |
| Frame | Galvanised steel or pressure-treated timber | A steel frame is the most reliably recoverable part. |
| Skirt | Synthetic or cedar | Usually comes off first. |
The pack
Behind one panel sits the equipment bay: a circulation pump, usually one or more jet pumps, a heater, a control board, and on some units an air blower. This is where the recoverable metal is. Pump motors have copper windings, and heater fittings are often brass or copper.
What it weighs
Weight varies a lot by size and model, so check the manufacturer’s spec sheet if you have it. Even empty, a spa is too heavy for two people to carry out whole. Water adds about 8.3 lb per gallon, so a full spa is far heavier again. That is why spas are drained and cut into sections rather than carried.
Why the bond is the whole problem
Sprayed polyurethane foam sticks directly to the fibreglass. There is no clean layer to peel apart. A refrigerator is worth taking apart because the steel and compressor pay for the labour. A spa shell is not.
So the shell usually goes to construction and demolition waste. We would rather say that than put a recycling percentage on a page. Where each material goes.
One practical consequence
Because the foam is bonded, a spa that has leaked can soak water into the insulation and keep it. A waterlogged spa can be much heavier than its spec sheet. If yours has been sitting with a cracked shell, say so in your quote request. It can change how we plan the job.